How to Reset Jlab Go Air

Jlab Go Air won’t turn off? How to reset Jlab Go Air? Jlab Go Volume too low? Jlab Go left earbud not working? Jlab Go Air not connecting to each other? Jlab Go Air right earbud not working? Jlab Go Air red light blinking?

If you are experiencing one of these problems listed above, then you have no other choice but to carry out troubleshooting on your Jlab earbud device. Well, part of the troubleshooting or solution to fix most of these problems is resetting.

In this post, we will e showing you the simple method to reset your Jlab device. So follow the steps below to do a reset on your Jlab Go Air device.

How to Reset Jlab Go Air

Step 1: Make sure your Earbud is in the charging case and then forget the “JLab GO Air” from Bluetooth device settings.

Step 2: Now tap on the one earbud in the charging case seven (7x) times. This will make the Earbud flash blue three (3x) times.

Step 3: Next, tap the other earbud in the charging case seven (7x) times. This Earbud will flash blue three (3x) times.

Step 4: Finally, take the earbuds out of the case. This will flash solid white and the other will flash white/blue.

Step 5: Done. You can now cononect your earbud via Bluetooth.

Remember, you may need to repeat steps 2 and 3 until its successful. However, if you encounter any issues, you can contact Jlab customer support for assistance.